Couplings · products coming soon
Torque Limiter Coupling
A torque limiter and a flexible coupling in one unit. It joins two shafts and slips at a set torque, so a jam or overload cannot damage the motor, gearbox or machine.
- Set the slip torque a little above the highest working torque.
- Drives again once the overload clears; no shear pins to replace.
- Both hubs come with a pilot bore, ready to be bored to your shafts.
Not sure which type? Compare them
| Type | Misalignment | Backlash | Shock damping | Torque | Best for |
|---|---|---|---|---|---|
| Jaw Coupling | Low, about 1° | Low | Good | 3–1,100 Nm | Motors to pumps, fans and gearboxes; fail-safe |
| Pin Bush Coupling | Low, about 0.5° | Low | Good | 50–50,000 Nm | Large motors in heavy industry; bushes change easily |
| Tyre Coupling | High, up to 4° | Some | Very good | 24–6,300 Nm | Shock loads and shafts that are hard to align |
| Gear Coupling | Medium, about 1.5° | Some | None | 500–100,000 Nm | Very high torque in a small size; needs grease |
| Resilient Coupling | Low to medium, about 0.3° | Low | Good | 50–100,000 Nm | Heavy drives with shock loads: conveyors, crushers, mills |
| Disc Coupling | Low, about 1° | Zero | None | 50–10,000 Nm | High speed and precision, no lubrication |
| Servo Coupling | Low to medium | Zero | None | 0.5–500 Nm | Servo motors, encoders and ball screws |
| Chain Coupling | Low, about 1° | Some | None | 50–20,000 Nm | Simple, compact drives; easy to disconnect |
| Torque Limiter | Depends on the drive it carries | Low | None | 2–5,000 Nm slip setting | Protecting machines from jams and overloads |
| Torque Limiter CouplingYou are here | Low to medium, from its coupling | Low | Depends on the coupling | 2–5,000 Nm slip setting | Joining two shafts and protecting them from overloads |
| Nylon Gear Coupling | Medium, about 1° | Low | Some | 10–2,000 Nm | Pumps and general drives; no lubrication, quiet |
| Locking Assembly | None, it is a rigid shaft-hub joint | Zero | None | 20–100,000 Nm | Fixing pulleys, sprockets and hubs to a shaft without a keyway |
| Taper Bush | None, it is a rigid shaft-hub joint | Zero | None | Set by the bush size | Fitting pulleys, sprockets and coupling hubs to a shaft, no boring needed |
Find a torque limiter for your drive
Set the slip torque a little above the highest working torque and below what would damage the machine.
Fill in any field to narrow the table below.
Products coming soon
Torque Limiter Coupling sizes are being added. Meanwhile, send us your shaft sizes and torque and we will quote.